DIY Vibrating Dildo: Is One Dick Not Enough? Let’s Make Another!

Creating your very own vibrating dildo can be an exciting project, and it’s easier than you might think! Here’s everything you need to get started on this DIY adventure.

What You’ll Need

• Molding mix
• Popsicle stick
• Spatula for mixing
• Vibrator (included in your kit)
• Silicone mix
• Thermometer

Getting Started

Since we don’t have a handy model available, let’s improvise! Follow along with the kit instructions, and you’ll be ready to create your own in no time.

Step 1: Preparing the Molding Mixture

1. Measure and Cut: Begin by measuring the length of an erect penis in the provided plastic cylinder. Make sure to leave about 1 to 1.5 inches for allowance, then cut the cylinder to size.
2. Mix the Molding Powder: Use the thermometer to measure the right amount, then pour the molding powder into a bowl. Mix thoroughly with a spatula for no longer than 60 seconds.
3. Time is Key: After mixing, you’ll have exactly two minutes to complete the next steps, so work quickly! If the mixture is a bit lumpy, don’t worry—it’ll still work.
4. Pour into the Mold: Once mixed, quickly pour the molding mixture into the tube.
5. Insert: Carefully insert the erected penis into the tube and press it firmly against your body. Ensure the penis is in place before your two minutes are up.
6. Let it Set: After a few minutes, gently touch the mold to check if it has solidified. If so, remove the penis from the mold. For the best results, allow the mold to air dry for about two hours.

Step 2: Creating the Silicone Dildo

1. Prepare the Silicone: Empty the two jars of liquid silicone into a disposable cup. Use your popsicle stick to get every last bit out.
2. Mix the Silicone: Stir the silicone mixture for about two minutes until it’s well combined.
3. Pour the Mixture: Carefully pour the silicone into the mold until it’s about an inch from the top.
4. Insert the Vibrator: To position the vibrator correctly, you can either cut an X in a piece of cardboard or use the leftover part of the cylinder, as shown.
5. Let it Cure: Allow the mold to sit for about 24 hours to ensure everything cures completely.

Final Touches

After 24 hours, carefully remove your finished replica from the mold.

Enjoy Your Creation!

Congratulations! You now have a unique, easy-to-clean vibrating dildo that you can customize to your liking. Enjoy exploring all the sensations it has to offer!

Also Read :

How to Use a Vibrating Dildo? Your In-depth Guide